In nearly all situations, most people spend quite a lot of money purchasing their lift truck. Thus, it is really essential to take proper care of it in order to protect your investment well into the long run. It is really a good idea to know the procedures that are carried out during the maintenance and care of this piece of equipment.
By starting up the forklift and listening carefully how it runs is one of the best ways to tell how good the engine is performing. For example, if there are any knocks or misses, the equipment is faulty and this must raise several concerns. What's more listen closely for any squealing noise that come from the belts since these sounds will provide you with a lot of information.
When doing maintenance, some of the main parts you would have to pay attention to consist of the safety warning devices, horn, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty parts have to be replaced as soon as they are noticed. It is also vital to inspect the wiring.
After the above parts have been checked thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each and every battery cell must be checked so as to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
Once the oil change has been carried out and new filters have been fitted, visually inspect the drive axle from beneath the machinery. Be sure to grease the axle if there is any grease fitting. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. Afterwards, check every other part of the equipment including the wheels. If any kind of issue or fault is detected, be sure to address it immediately so as to make sure the machinery is working at its safest and optimum levels.